Gyeon Q² Prime 30ml

Combined with adding great durability and excellent self-cleaning ability this coating protects your car’s paint for well over a year.

This paint protection coating offers a contact angle of well over 90 degrees meaning water beads/sheets off very easily so the paint is less susceptible to water marks, it has a great self-cleaning ability after even just rain and makes washing a breeze as dirt is released form the paint much more easily.

Tests on Gyeon Prime show that over 80% of the super hydrophobic effect still remained after 12 months, therefore providing optimum car protection for the person who is looking for that long-term option.

This Quartz Coating is also designed to offer some improved scratch resistant, with Prime adding a further 2H to the hardness in average.

Q2 PRIME Coating from Gyeon will leave your paintwork protected and with an incredible deep glossy, candy-like finish that is easily maintained to leave your car looking like new. This kit even comes with Gyeon Cure which is ideally used after a regular wash, adding even more glow and ongoing protection for your car.

This Kit contains:

1x PRIME 30ml, 1x Cure 100ml, applicator set.

For best results

The use of Gyeon Prep Surface Cleaner is a MUST before any Gyeon Coating application.

Ensure your car is clean, dry and free from contamination; so wash thoroughly and dry. Clay your car if required prior and use Gyeon Prep to remove all traces of old wax, polish or oils with a new good quality microfibre cloth. It is highly recommended to use a good surface cleaner such as Gyeon Prep before application of any Gyeon Coating.

Shake the Gyeon Prime well, take one of the applicator cloths on top of the applicator block and apply a small amount of coating to it. Wipe over a small section (about a quarter to half a panel) gently ensuring you pass over all the area at least two times to provide an even thick coverage. Wait for 1-2 minutes depending on heat/humidity the coating should haze quickly, then wipe off completely with a good quality microfibre cloth. Repeat section by section for all other panels.

We recommend not getting the coating wet for at least 24 hours to allow it to properly cure, and not washing your car for a minimum of 7 days.

It is advised that you coat your car in a cool and covered area. Do not apply in direct sunlight.